Hi folks
Running a new build Scootopia 186 with a 28phbh with a tea strainer filter and AF clubman. Runs fine, starts fine and plug colour fine. I’ve adjusted the mix screw in and out and settled on the best spot for pick up and returning to tickover but it still remains very lumpy. It’s fine at start up with the choke on. Any ideas most appreciated
Lumpy tickover with PHBH
-
- registered user
- Posts: 1208
- Joined: Sat Mar 28, 2009 1:10 pm
- Location: hartlepool
- Contact:
Check pilot jet and pilot route is not blocked.....thoroughly clean the whole carb through.
Also check your tank and petrol filter aren't full of crap
Also check your tank and petrol filter aren't full of crap
-
- registered user
- Posts: 1208
- Joined: Sat Mar 28, 2009 1:10 pm
- Location: hartlepool
- Contact:
55 defo big enough pilot.
Don't bank on the carb been clean from new - when I had this it was crap in the carb and it took a couple of cleans. Tank and filter was clean
Don't bank on the carb been clean from new - when I had this it was crap in the carb and it took a couple of cleans. Tank and filter was clean
-
- registered user
- Posts: 450
- Joined: Thu Oct 25, 2012 2:49 am
- Main scooter: GP-1971-Ts230/S2-1960-Ts230
- Contact:
Has engine had a leak down test?stand63 wrote: ↑Sun Mar 29, 2020 9:17 am Hi folks
Running a new build Scootopia 186 with a 28phbh with a tea strainer filter and AF clubman. Runs fine, starts fine and plug colour fine. I’ve adjusted the mix screw in and out and settled on the best spot for pick up and returning to tickover but it still remains very lumpy. It’s fine at start up with the choke on. Any ideas most appreciated