Its probably been asked before. I cannot find the answer.
Which is best the px200 or p200e engine, in terms of aftermarket cylinder, gearing and tuning etc.
Robbie
Px200 or p200e
-
- registered user
- Posts: 394
- Joined: Thu Jan 09, 2014 7:34 pm
- Main scooter: li150
- Location: York
- Contact:
For myself the EFL motor without question. Only downside from the earlier motor is the internal rather than external hub seal.
-
- registered user
- Posts: 1208
- Joined: Sat Mar 28, 2009 1:10 pm
- Location: hartlepool
- Contact:
I use a combination of both
early casings as I don't want autolube - as said it has the external rear hub seal but I use the EFL gearbox parts (better cruciform set up) and a COSA clutch.
other than the g/b parts fundamentally everything else is the same/interchangeable - crank, top end etc
Gaz
early casings as I don't want autolube - as said it has the external rear hub seal but I use the EFL gearbox parts (better cruciform set up) and a COSA clutch.
other than the g/b parts fundamentally everything else is the same/interchangeable - crank, top end etc
Gaz
-
- registered user
- Posts: 394
- Joined: Thu Jan 09, 2014 7:34 pm
- Main scooter: li150
- Location: York
- Contact:
OK,
Thank you for the replies.
Robbie
Thank you for the replies.
Robbie