Page 7 of 7
Re: Handlebar choke kit /cooling/tuning aid/engine sa
Posted: Mon Sep 22, 2014 1:22 pm
by coaster
This will get the job done but you will need your own cable and bracket to fit on the throttle housing
http://www.ebay.co.uk/itm/Vintage-motor ... 58b549487b
Re: Handlebar choke kit /cooling/tuning aid/engine sa
Posted: Sat Oct 11, 2014 7:33 pm
by gp200ts1
Are these kits available again yet?
Re: Handlebar choke kit /cooling/tuning aid/engine sa
Posted: Mon Oct 13, 2014 6:40 pm
by sydduckett
Awaiting levers at mo, darrell old me but didn't say when he would get them
Re: Handlebar choke kit /cooling/tuning aid/engine sa
Posted: Mon Oct 13, 2014 11:50 pm
by Darrell Taylor
levers due in end of week but be a few weeks making the kits up
ta..
Re: Handlebar choke kit /cooling/tuning aid/engine sa
Posted: Sat Oct 25, 2014 7:44 am
by rbgaz
U got any made up yet darrell
Sent from my iPhone using Tapatalk
Re: Handlebar choke kit /cooling/tuning aid/engine sa
Posted: Mon Nov 03, 2014 4:47 pm
by rbgaz
Hi darrell. Just seen a pic of one on your Facebook page which shows a temp gauge built on to bracket as well r u selling the gauge as well ? If not do u know were this one came from cheers
Sent from my iPhone using Tapatalk
Re: Handlebar choke kit /cooling/tuning aid/engine sa
Posted: Sat Jan 10, 2015 7:21 pm
by sydduckett
Did anyone else get one of the kits with the digital gauge? I only ask as i want to cut the wire so i can pass it through a drilled hole in the headset. Can it be cut and then re wired inside the headset? I dont think i will be able to re use the origonal connector as it seems to be a sealed unit so will need to use a new one.
Thanks
Sef