www.scooterotica.org

Has anyone got a good spec for this on a non reed topend.
Not using a filter and got a PM/JL3 pipe.
Ta

125, 150, 175, 200, 225, 250......?

Cast? Ally? Standard? Ported?

Oh yeh.4got all that s**t.Its a 200 road tuned iron topend.

Cheers for that.Its not a common carb for this kit so there is very little info.

Oddly enough...I need the same info for a TV length 190 iron top end (your old engine again too Soosh) will try running with a PM25 pipe also.

Already got the carb, just require some pointers re' the jetting.

Was thinking:

Main 128
Atomiser DP266
Needle U16
Slide 50
Pilot 60 with B40
Choke 60

The above is lifted from AF's site and is the spec for a TS1225, except I've changed the Main from 150 to 128.

maybe you should stop messing about and book it in for a dyno session matey..

Mate,if you ever have that motor apart,id love to know the timings of it.If you do,PM me if possible.I never did look at that before i sold it.Whats it like with a PM pipe? That thing would rev its tits off with the RS clubman on it.

When top end comes off I'll do that for you. Not fitted PM yet as ordered a reworked B-race retro that'll rev on a bit more. B-race reckons it'll be a good match for that kit. Out of interest can you remember what gearbox is in that engine?

Cheers Stu