had it last week on a mates lambretta...
once again...
on your original 6v lambretta use 15/3w bulbs and a new earth wire and you have better lights
instantly...
loads of people use 21/5w or 18/3w bulbs...
but 15/3w taillight bulbs should be fitted innocenti says.
they are a little bit difficult to get, so just buy some if you get them. most dealers sell the wrong ones and NOT 6v 15/3w bulbs.
in the uk you can get them from few scooter shops (eg camlam or scootopia) or here:
http://www.kjm-supplies.co.uk/products/ ... -BULB.html
6V original: use a taillight 15/3w bulb !
-
- registered user
- Posts: 1154
- Joined: Thu Jan 08, 2009 12:08 am
- Main scooter: '70 GP150 [TS1 225]
- Location: Merseyside
- Contact:
This is a good post for anyone running standard 6v electrics. These bulbs are, in my experience, hard to get and, along with making sure you have a 12v speedo bulb, do resolve a lot of the poor lighting issues, in particular related to the rear brake light.
-
- registered user
- Posts: 465
- Joined: Sun Mar 22, 2009 5:15 am
- Location: Richmond Virginia, USA
- Contact:
I third that emotion.Soulpunk wrote:had it last week on a mates lambretta...
once again...
on your original 6v lambretta use 15/3w bulbs and a new earth wire and you have better lights
instantly...
loads of people use 21/5w or 18/3w bulbs...
but 15/3w taillight bulbs should be fitted innocenti says.
they are a little bit difficult to get, so just buy some if you get them. most dealers sell the wrong ones and NOT 6v 15/3w bulbs.
in the uk you can get them from few scooter shops (eg camlam or scootopia) or here:
http://www.kjm-supplies.co.uk/products/ ... -BULB.html
That's not going anywhere...