Piston circlip broke and went up the side of the piston
Can this barrel still be salvaged and used and if so what is the best way to do it?
As you can see the only real damage is to the boost port edges, can I just smooth these with a dremmel?
Is this TS1 barrel still useable?
Hello,
Piston circlip broke and went up the side of the piston
Can this barrel still be salvaged and used and if so what is the best way to do it?
As you can see the only real damage is to the boost port edges, can I just smooth these with a dremmel?
Piston circlip broke and went up the side of the piston
Can this barrel still be salvaged and used and if so what is the best way to do it?
As you can see the only real damage is to the boost port edges, can I just smooth these with a dremmel?
-
Grumpy225
- registered user
- Posts: 650
- Joined: Sat Nov 24, 2012 7:59 am
- Main scooter: Gori200, rt195, ld150,rb20
- Location: Bakersfield, CA
- Contact:
The seize marks all around the boost ports need to be looked in to.
As far as the physical damage to the ports you should be able to smooth them out without too much issue.
As far as the physical damage to the ports you should be able to smooth them out without too much issue.
They aren't actually seize marks Grumpy, they are where the circlip tang was dragged up and down the barrel.
I was going to try and carefully polish them out
I was going to try and carefully polish them out